PREDATOR  212 cylinder head 32/28  * PAULS KARTS * - PORTED/GUIDES

Description

Predator cylinder head
By Paul , from Paul’s karts
PRICE DROP 0 ... DOES NOT COME WITH VALVES ... ( welded intake tube is a add on item ) welded intake tube can be added to any of the heads I sell for 0 ..the listing is for the head “as cast” with moods listed below. can add valves & springs back if needed and payed for..EXTREME PERFORMANCE HEAD SPECIFICALLY MADE FOR RACING ..  PRICE AS MRKED .. MUST READ OPTIONS ... TONS OF MODS DONE ... !!!!!! AWESOME CYLINDER HEAD !!!!!!
Hand picked casting head ( castings vary based on vendor )
Inspected , hot tanked, and crack detected
Valve seat ea (2) =
Big valve seats installed per seat x (2) = 0
32/28 seats
Recommended for use with 42lb -60lb valve springs and stainless steel valves ,for high rpm controls and fast ramps on big cams ( valve train can be added on for a fee ) available under “sellers other items”
Valve spring pockets cut to accept dual springs and to square springs to valves for better stability
Bronze guides ea x (2) =
Guides installed ea x (2) =
Guides reamed to 5.5mm and honed to perfect clearance for si valves ea x (2)
Ported by Paul’s karts from you tube 0
Epoxy used where needed in intake port to balance port velocity on flow bench an hr (2) hrs = 0
Polished exhaust port
Polished chamber
Multi angle valve job , angle widths set up for high rpm power and max air flow per cut per seat (5 cuts (2) seats = 10 cuts ) =0
Valves fully un-shrouded on mill with trademark radius bowl combustion chamber reliefs cutter = $ 80
Head gasket surface milled .002” for factory fresh seal ,or better
Head flow tested , velocity probed and low velocity areas filled with epoxy , and head flowed on laminar smoke machine to set up valve seat angles, combustion chamber valve reliefs and radius chamber cuts to optimize head flow and cylinder fill.
Head will work on 2.756” 2.815” and 3” bore (NOT RECOMMENDED FOR 2.675” BORE)
Head quality checked ,cleaned and tested
Recommend for use with 25/26/27/28 mm carb and unrestricted exhaust for maximum flow
Professional quality , professional service , highest power cylinder head on the market today.
Picture of a head is for reference only , will be similar to head shipped .. hand made ... so products may vary slightly , and will try to meet your engines needs if info left as “message to seller” when purchased.
Thank you for choosing Paul’s karts